PRI's into BCM

[BobZahn]

I have three PRI's going into a BCM 400 and I recently had one turned off. I want to remove that PRI from the machine but the PRI's are not labeled. Is there any way to determine which PRI is which? I looked at BCM monitor and I can see the bank of lines that are no longer active. Lines 91 to 113.

Thanks

 

[biv343]

If you know the circuit ID of the PRI that was turned off, disconnect it at the smartjack and then look for the card that has alarm lights on it. That's the only way I can think of if your installer didn't label anything for you.

 

[acewarlock]

Disable BUS 6 and light will come on card.
BUS 6 (91-113)