Other than
a) capture form image in picture
b) rotate picture (as necessary)
c) use paintpicture method
is there another way to print a form to a Zebra LP 2844 such that it lines up within a 5 part label (on to the part that I want to use) such that it prints at x,y on the label?
This is hair tearing stuff.
Else, how does one make a CR9 report print to point x,y?
Ya see I have a compound label used by another application and I want to lob my "bits" onto a label within the group. Its top left if always defined at point x,y.
a) capture form image in picture
b) rotate picture (as necessary)
c) use paintpicture method
is there another way to print a form to a Zebra LP 2844 such that it lines up within a 5 part label (on to the part that I want to use) such that it prints at x,y on the label?
This is hair tearing stuff.
Else, how does one make a CR9 report print to point x,y?
Ya see I have a compound label used by another application and I want to lob my "bits" onto a label within the group. Its top left if always defined at point x,y.
