I am trying to print to a Zebra printer using the command
SET PRINT TO COM1
SET PRINT ON
and then I pass the printer commands.
When I use the SET PRINT ON command, I get an error that the printer is not available. I think that my problem may be the baud rate because I can print a test page from my printer setup in Windows.
The baud rate on my printer is 19200. Does the baud rate need to be adjusted to 9600 on any printer that is used to print in FOXDOS?
Also, I can create a text file in DOS for windows and copy the file to the COM1 and it prints fine but when I try the ! DOS command from FOXPRO with the same file - I get the error that the printer is not available.
Thanks in advanced !
KFlasph
SET PRINT TO COM1
SET PRINT ON
and then I pass the printer commands.
When I use the SET PRINT ON command, I get an error that the printer is not available. I think that my problem may be the baud rate because I can print a test page from my printer setup in Windows.
The baud rate on my printer is 19200. Does the baud rate need to be adjusted to 9600 on any printer that is used to print in FOXDOS?
Also, I can create a text file in DOS for windows and copy the file to the COM1 and it prints fine but when I try the ! DOS command from FOXPRO with the same file - I get the error that the printer is not available.
Thanks in advanced !
KFlasph