Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Prime Set and Control Set Question
- Thread starter nooop
- Start date
There are a number of places to have a prime set one is for the trunks/Lines/PRI I usualy put none then there are the target lines that should match the extention it is assinged to.It changes all prime when you enter it in the PRI/VOIP trunk section.And no you have to add or change each target prime one at a time.
acewarlock
Technical User
There no way that could have changed.
how did you add a conf phone?
This is a Signature and not part of the answer, it appears on every reply.
This is an Analogy so don't take it personally as some have.
Why change the engine if all you need is to change the spark plugs.
how did you add a conf phone?
This is a Signature and not part of the answer, it appears on every reply.
This is an Analogy so don't take it personally as some have.
Why change the engine if all you need is to change the spark plugs.
- Thread starter
- #4
I plugged a new Digital Nortel Conferencing unit it, and it grabbed a DN that I didn't want. I renamed the DN by deleting it, and changed it. It may have been coincidence. But I now have a different prime set for all my target lines. I only have 40 DID's so i manually put those back, but I am just stumped by what I did.
Thank You
Thank You
norstarboy125
Vendor
by any chance was this dn on port 101...
- Thread starter
- #6
acewarlock
Technical User
Any time you plug any phone into a port it will take the Default programming that is programmed in the system unless that port is already programm for the same model of phone that your plugging in. Also when you plug in a phone it doesn't just grab any old DN, it take the DN that is assigned to the port by the system or the one you assigned when the system was setup. If you didn't do a setup originally, then everything will be at the default.
This is a Signature and not part of the answer, it appears on every reply.
This is an Analogy so don't take it personally as some have.
Why change the engine if all you need is to change the spark plugs.
This is a Signature and not part of the answer, it appears on every reply.
This is an Analogy so don't take it personally as some have.
Why change the engine if all you need is to change the spark plugs.
- Status
Similar threads
- Locked
- Question