PRI5033

[falwiz]

Can someone help me find a way to track down a PRI5033 error? I've been trying to track them via DCHL messaging with no luck. The route in question for these 6 T1 are used to connect our Option 81 to a Cisco Call Manager. If you need more info I can add to this but I just wanted to start somewhere.
Thank You.

 

[GHTROUT]

Generally, posting the books error definition will save us time looking it up. Have you found it in your books? I see it in the Rls 5.5 version books.

It looks like the error outputs with other info. Did that lead you anywhere?

[tt]
An application has requested to send on a QSIG a non-call related message
received on MCDN but the QSIG RCAP is not configured on the outgoing
link or the service is not supported on QSIG. The message is rejected.
Output: DCH or DSL number, PRI/BRIT type, Service identifier. The
following service identifiers are defined:
1. Network ring again
2. Network ACD
3. Network Attendant Service
4. Network Message Center
5. Trunk Route Optimization
6. Network Call Trace
7. Remote Virtual Queuing
8. VNS service
9. Network Remote Call Forward
10. Network Radio Paging

[/tt]

[©] GHTROUT.com [⇔] A Variety of Free Resources for Nortel Meridian/CS1000 System Administrators

 

[SL1M1]

I had this problem before I upgraded from Rls.4/81C to Rls5.5 CS1000M MG, if memory serves me correctly I'm sure a patch resolved it but it may also be your RCAP settings which either relates to Cisco Name Display format or NMS over QSIG...Have you all the suggested Dchannel/RCAPs set ?

Cheers!!

 

[falwiz]

Sorry for that here is the error.

PRI5033 72 4
"An application has requested to send on a QSIG a non-call related
message received on MCDN but the QSIG RCAP is not configured on the
outgoing link or the service is not
supported on QSIG. The message is rejected. Output: DCH or DSL number,
PRI/BRIT type, Service identifier.

4. Network Message Center

This PBX is release 3.0

 

[falwiz]

Yes my RCAPS are a like and here is what i have.

ADAN DCH 72
CTYP MSDL
GRP 0
DNUM 12
PORT 2
DES QSIG_MGCP_CISCO0
USR PRI
DCHL 72
OTBF 32
PARM RS422 DTE
DRAT 64KC
CLOK EXT
IFC ISGF
PINX_CUST 0
ISDN_MCNT 300
CLID OPT0
CO_TYPE STD
SIDE NET
CNEG 1
RLS ID **
RCAP COLP NDI CCBI CCNI PRI DV3I CTI QMWI
PR_TRIGS DIV 2 3
CNG 2 3
CTR2 2 3
PR_RTN NO
MBGA NO
OVLR NO
OVLS NO
T310 120
T200 3
T203 10
N200 3
N201 260
K 7
PRI5033 DCH: 72 DATA: 4

Now just to add to this I have 11 more sites configuted like this with different Nortel PBXs ranging form Option 11s to 81s. 4 of these sites including this one have a Call Pilot. All the PBXs are running 3.0 and configured the same way.