PRI

[ben694]

Warning: This may be a stupid question.

Trying to setup an IP Office for when a new PRI is delivered. The telco sent me a sheet with the framing, switch type, coding, etc. Looks like it's just the default setup. However, it says "Routing Digits = 10." In my very limited experience with PRIs, it's usually 4. So I assumed that I just need to enter in 10 for routing digits into the line on the IP Office. Well, if you try that, you'll notice it doesn't let you put in 10. It only allows for a single digit.

Will having it set to 4 work? I'm sure I just don't understand how the whole routing digits thing works.

 

[smokinjoe2938]

10 digits is fine and yes leave it at 4 that has nothing to do with what you are trying to do; Incoming Routing Digits: Default=0 (present call immediately)
Sets the number of routing digits expected on incoming calls. This allows the line to present the call to the system once the expected digits have been received rather than waiting for the digits timeout to expire. This field only affects T1 line channels set to E&M Tie, E&M DID, E&M Switched 56K and Direct Inward Dial so as you can see this does not apply to you.