Sep 19, 2008 #1 jdisatech Technical User Jan 3, 2007 17 US I am swapping out a gat8 with a dti for a pri in a bcm 50 and my board just tells me enabling and never enables?
I am swapping out a gat8 with a dti for a pri in a bcm 50 and my board just tells me enabling and never enables?
Sep 19, 2008 #2 Dasheen Programmer Oct 5, 2007 1,633 CA Are the dipswitches in the default position? Did u change the MBM type in programming. Upvote 0 Downvote
Sep 20, 2008 #3 snowman50 Technical User Nov 17, 2007 2,601 GB as long as you have set it up in telephony resources for PRI and Enable the module the system will see the card. Has the lights on the card steadied yet. Three leds showing GREEN You wiil only see the customer ORANGE led on until you connect to yous PRI service. When your lines are in service it will say enabled. Check active lines and your lines should appear then all is well. Upvote 0 Downvote
as long as you have set it up in telephony resources for PRI and Enable the module the system will see the card. Has the lights on the card steadied yet. Three leds showing GREEN You wiil only see the customer ORANGE led on until you connect to yous PRI service. When your lines are in service it will say enabled. Check active lines and your lines should appear then all is well.