Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

PRI TIE trunk dialing issue

Status
Not open for further replies.

motox2

Programmer
Jun 21, 2007
426
GY
Hello i have a dialing issue i was hoping somebody could help me with. I have a BCM 400 thats connected via PRI2 TIE to an OPT11 meridian system. My PRI route seems to be fine, i can place calls back and fourth just fine between systems. I think the issue im having is on the BCM side but i can seem to figure it out. This is a lab system that was recently reloaded, and the CDP on the M1 system has been setup to steer the DN's accordingly. So anyway heres what i can and cant do....
1. place call from BCM to BCM, no problem
2. place call from BCM to M1, no problem
3. place call from M1 to BCM x2221, no problem (x2221 PRIME DN)
4. heres the issue....when i place call from M1 to BCM x2222, it does not ring, instead the call is being sent to, and ringing the PRIME DN x2221.

Like i mentioned, im sure this is a BCM config problem, but i cant figure it out. The software is 3.7 in case you need to know. thanks for your help
 
Check to make sure that you have a Target Line assigned to ext # 2222 with the correct received digits. The prime line of all target lines is ext 2221 so if not programmed all calls from M1 to your BCM will route to 2221.
 
awesome!! i will check that out first thing in the AM and see what happens. Thanks again!!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top