pri target lines

[curt2k]

hi,to all.i have 0x32 w/6.1 using pri.i would like to know if i can put a target line where line one,two and so on normally would appear on a m7208 telephone,instead of using the intercom buttons above the handsfree button.if so could you please let me know how to do this.
thanks so much.
curtis@myteledata.com

 

[MarvO1]

Yes, go under Terminals and Sets, then Line Assignments, then assign the target lines you want. Set then to APPEAR and ring, instead of ring only.

MarvO said it

 

[Giljo]

The buttons may however not show in the position of the Intercom buttons. Intercom buttons are "hard coded" to appear in their specific positions. Once the tgt lines have been made to appear you can move them with feature 81 to a more suitable position.

(referencing Norstar coding on Nortel BCM's but if I recall correctly this works/is correct on any norstar platform.)