PRI Problem Outgoing Calls

[ph3189]

I am having a problem setting up the Merlin Magix system to make calls out over a PRI line. I now have a functioning PRI line and can successfully place and route inbound calls using Routing by Dial Plan, but I cannot call out.

I have assigned 22 of the Lines to a pool (890). After I assign the lines, the red led light next to the line button for each line comes on. When I try to call out (by dialing 890 and the number) I get a fast busy, and the telco does not see anything coming towards them.

I left the Network Selection table and the System Access table alone. I put one entry in the Call-by-Call service table with call type of Both and Service of DMS-100Local.

Any ideas?

 

[Guest_imported]

You have to set up the service table (I think) for each digit 0 through 9, and set the type to 'any', I think. I'd check my programming Here's my network setup... took me forever to find, but I was in the same boat, and this fixed it.

Network Selection Table

Entry Number: 0 1 2 3
Pattern to Match: 101**** 10***

Special Service Table

Entry Number: 0 1 2 3 4 5 6 7
Pattern to Match: 011 010 01 00 0 0
Operator: none none none none none none none none
Type of Number: I I I N N N N N
Digits to Delete: 3 0 0 0 0 1 0 0

Call-By-Call Service Table

Entry Number: 0 1 2 3 4
Pattern 0: 0
Pattern 1: 1
PRI INFORMATION


Pattern 2: 2
Pattern 3: 3
Pattern 4: 4
Pattern 5: 5
Pattern 6: 6
Pattern 7: 7
Pattern 8: 8
Pattern 9: 9
Call Type: BOTH BOTH BOTH BOTH BOTH
NtwkServ: No Service DMS-TieTrk
DeleteDigits: 0 0 0 0 0

Entry Number: 5 6 7 8 9
Call Type: BOTH BOTH BOTH BOTH BOTH
NtwkServ:
DeleteDigits: 0 0 0 0 0

 

[ph3189]

Thank you. That worked!