PRI not coming up

[ld20kate]

I was hoping that a second set of eyes could look at these settings from the telco and let me know if these look correct for an Option 11:


ISDN PRI Protocol: B8ZS/ESF with National ISDN-2
New or Existing Trunk Group: New
Quantity of Trunks Ordered: 23B + 1D
Trunk Type: Two-Way (DID/DOD)
Signal Type: Q931 PRI
Trunk Selection Sequence: Ascending Sequential
PBX Store & Route Digits: Yes
If Yes, Number of Digits to be sent: 4
Pilot Number: 702-634-7000
Assign Test Number: 702-634-7000
POTS/DID Numbers to be Added (Inc. DID): 702-634-7000-7999
Backup D Channel Assignment: None
Customer Switch Type: Dedicated
Return DT on Seizure: No
Caller ID Name & Number: Yes
InterLATA PIC: 5046
IntraLATA PIC: 5046
Yield to Glare: Yes
Call Blocking: No


MY SWITCH:
ADAN DCH 10
CTYP TMDI
CARD 02



PAGE 001

PORT 1
DES Local
USR PRI
DCHL 2
OTBF 32
PARM RS232 DTE
DRAT 64KC
CLOK EXT
IFC NI2
ISDN_MCNT 300
CLID OPT0
CO_TYPE STD
SIDE USR
CNEG 1
RLS ID **
RCAP COLP
MBGA NO
OVLR NO
OVLS NO
T310 120
T200 3
T203 10
N200 3
N201 260
K 7
BSRV NO


DLOP NUM DCH FRM TMDI LCMT YALM T1TE TRSH
PRI 02 24 ESF YES B8S FDL 0 00
MISP

 

[janaya]

If this is a new circuit, please ensure the carrier has released the Bchannels and the Dchannel. If new circuit in US, this is normally the last step of the turnup.

John Anaya
Amdocs Inc.
ACSS/ACIS - CS1000 Rls 7.5/Call Pilot 5
ACSS/ACIS - SME - IP Office 8.0
APSS/APDS - Avaya UC Services

Public Profile

http://www.linkedin.com/pub/john-anaya/25/1b9/a9b/

 

[ld20kate]

The circuit is turned up. If I unplug the PRI from the Option 11 and plug it in to an Avaya IP Office, it comes right up and works fine.

 

[KCFLHRC]

If you are going from the Opt 11 to an IPO then you are probably using a crossover cable? Are you using a straight through cable going to the Telco?