PRI is showing red

[BCU]

I have a PRI issue in my site and its showing RED
Below is the output
>ld 96
DCH000
.stat dch
DCH 100 : OPER EST ACTV AUTO DES : Voip_Trks
DCH 200 : OPER RLS AUTO DES : Earthlink
.****
OVL000
>ld 60
DTI000
.stat 200

PRI* TRK LOOP 200 - ENBL
FFMT/LCMT/YALMT: ESF/B8Z/FDL
TRACKING
SERVICE RESTORE: NO
YEL ALM PROCESS: YES
ALARM STATUS : RED
CH 01 - DSBL DID VOD * CH 02 - DSBL DID VOD *
CH 03 - DSBL DID VOD * CH 04 - DSBL DID VOD *
CH 05 - DSBL DID VOD * CH 06 - DSBL DID VOD *
CH 07 - DSBL DID VOD * CH 08 - DSBL DID VOD *
CH 09 - DSBL DID VOD * CH 10 - DSBL DID VOD *
CH 11 - DSBL DID VOD * CH 12 - DSBL DID VOD *
CH 13 - DSBL DID VOD * CH 14 - DSBL DID VOD *
CH 15 - DSBL DID VOD * CH 16 - DSBL DID VOD *
CH 17 - DSBL DID VOD * CH 18 - DSBL DID VOD *
CH 19 - DSBL DID VOD * CH 20 - DSBL DID VOD *
CH 21 - DSBL DID VOD * CH 22 - DSBL DID VOD *
CH 23 - DSBL DID VOD * CH 24 - DCH 200
.lcnt 200

PRI LOOP 200
TRSH CNT:
BPV -000
SLIPD -000
SLIPR -000
CRC -033
LOSFA -000
OS_BPV -002
OS_LOSFA-000
OS_YEL -000

I think I need to ask the local cabling vendor to check the circuit. Please suggest. I tried to disable and enable the loop.
But still it comes to RED alarm. Anything I need to do from my side?

-BCU

 

[KCFLHRC]

Yep, contact the provider. You can also put a loop back plug on the end of the cable and verify if it comes out of Red Alarm. The DCH wont come up but the loop will