Pri incoming call not working

[eliehelou]

Incoming call on pri not working

 

[kwbMitel]

This post probably the worst I've ever seen with respect to the lack of information provided.

I'm going to make 15 assumptions to get to this answer.

Is it plugged in?

**********************************************
What's most important is that you realise ... There is no spoon.

 

[wireman50]

Most likely to do with mis configured DID ( see post about noisy PR)....

 

[kwbMitel]

Yeah, I noticed it was the same poster after the fact

15 Assumptions may sound like an exaggeration but off the top of my head ...
[ol 1]
[li]System Type[/li]
[li]Software Version[/li]
[li]Hardware for PRI - Embedded or not[/li]
[li]T1 or E1[/li]
[li]Status of D Channel[/li]
[li]Status of B Channels[/li]
[li]Digital Trunks Programmed correctly[/li]
[li]Qty Digits received[/li]
[li]Digits after modification[/li]
[li]Digits match dialable numbers on system[/li]
[li]DID table active or not[/li]
[li]DID table programmed if active[/li]
[li]Outbound calls working or not[/li]
[li]Termination point can be dialed internally[/li]
[li]Communication received from Telco via trace[/li]
[/ol]


**********************************************
What's most important is that you realise ... There is no spoon.

 

[eliehelou]

Mitel ac version7 i receive 09618595 as digit

 

[wireman50]

what is your numbering plan?

 

[jpruder]

Trunk service having no absorb value?