PRI Help

[wpetilli]

I received this alarm and don't know what in the world this means.

'Blue Alarm Inquiry T Avaya Alarm: UDS1-BD Error Code: 1793() The Error number 1793does not exist'

Any help would be appreciated.

 

[mikeydidit]

1793 Any Blue Alarm
Inquiry test
(#139)
WRN
MIN
MAJ4
OFF test board location

Maintenance Alarms for Avaya
Aura™ Communication Manager,
Media Gateways and Servers
03-300430
Issue 5

Page 1245

Blue Alarm Inquiry Test (#139)
Note:
Note: The term "DS1 board" refers to the DS1 Interface circuit packs, the UDS1
Interface circuit packs, and the DS1 Interface Media Module.
A Blue Alarm is a signal sent by the remote DS1 endpoint when it is out-of-service. The Blue
Alarm Inquiry Test checks the Blue Alarm status of the remote DS1 endpoint.
When a local DS1 board detects a Blue Alarm signal from the remote DS1 endpoint, it transmits
a Yellow Alarm to the remote DS1 endpoint and sends a BLUE ALARM message to the system.
When the Blue Alarm is confirmed, the system places all trunks or ports of the DS1 board into
the out-of-service state. The inquiry test runs every 10 minutes until the Blue Alarm is cleared.
When the Blue Alarm is cleared, the DS1 board stops transmitting the Yellow alarm and places
the trunks or ports back into the service state they were in before the Blue Alarm occurred
This test is run on the following maintenance objects:
● DS1-BD (DS1 Interface Circuit Pack)
● MAPD-BD (MAPD Interface Circuit Pack)
● MG-DS1 (DS1 Interface Media Module)
● UDS1-BD (UDS1 Interface Circuit Pack)

When is the last time you helped someone, just because you were able to?

For the best response to a question, read faq690-6594

 

[wpetilli]

Thanks,,, is this a carrier issue or my board or my connection from smartjack to board? I did a test board xxxx long clear.