PRI enabler codes 2

[tkoon]

I have a customer with a MICS/ 6.1 software that has some remote sites that are tied together with point to point T-1's. We are going to add an additional site and would like to use a T-1 card that has been enabled with a PRI code that is no loger in use at the main MICS site for the new location. Does the PRI enabler code stay with the card or is it in the software where it was origonaly installed?
The remote sites are using Adtran units to send voice and data between them now and we have a T-1 card no longer being used at the main site.

 

[curlycord]

Key codes remain at the software.....you will need new one!

 

[senk1s]

it stays on the 0X32 module ... as long as the system ID is not changed.

 

[tkoon]

Thanks for the info