PPWeb Drill Through Problem

[thabrane]

Hello,
I am building reports in powerplay web. I have drill through set up on the cubes that are being used. I am having a strange problem in that drill through works fine for some reports and does not work at all for other reports. On the reports that it does not work for, I get no error message. I just get a blank browser window and a small yellow triangle with an exclamation point in the middle down in the lower left corner of the browser. It says 'error on page' next to it.
I have tried republishing the drill through reports. I can't figure out whats going on.
Could this have something to do with certain reports being created in PP client vs PP web?

Any help would be greatly appreciated.

Thanks

 

[thabrane]

Hello,
I think I have found the problem with my reports. I think that it has to do with creating reports and hiding various measures and measure folders.
when I created the report only pulling in one measure or measure folder, the drill through worked fine. When I pulled over the main measures folder and hid some things, drill through would not work.

 

[DoubleD]

Do you have your drill through set up at the cube level, or at the measure level?

Pain is stress leaving the body.

DoubleD

 

[thabrane]

I have the drill through set up on the cube.