Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Power Brick for 11xx/12xx phones

Status
Not open for further replies.
GordonKapesMZ4

GordonKapesMZ4

Programmer
Nov 28, 2010
922
US
Hi, I have an extra power supply left over from a Cisco IP phone, that does power up my 11xx/12xx phones. I want to make sure that it is an acceptable power source before I use the power supply permanently.Its a Input: 100-240V-500mA 50-60HzOutput: 48V---200 mA LPSSays it is "for use with information technology" equipment.Does anyone know if this acceptable for the 11xx/12xx phones or will it burst into flames or damage the phone? Thank you.
 
Status
Not open for further replies.

Similar threads

tdhaslett
  • Locked
  • Question
Hotline setup to four cell phones
Replies
1
Views
226
tdhaslett
tdhaslett
Michel$
  • Question
hi guys, After upgrading System Manager Communication Manager and Session Manager versions 8.1 to 10.2 SIP device phones display the error message "n
Replies
0
Views
227
Michel$
Michel$
Marcin Stasiek
  • Locked
  • Question
Looking for latest firmware for AVAYA ERS4550T-PWR
Replies
0
Views
247
Marcin Stasiek
Marcin Stasiek
Beg.inner
  • Locked
  • Question
Avaya Auth code on separate line for SIP phone
Replies
1
Views
206
Westi
Westi
R Wills
  • Locked
  • Question
Avaya Site Admin for MAC's on Avaya 8710
Replies
0
Views
97
R Wills
R Wills

Part and Inventory Search

Sponsor

Back
Top