Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations biv343 on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

POTS line on phone

Status
Not open for further replies.

coniglio

Technical User
Jun 17, 2003
1,886
US
if I want a POTS line to ring on a key on a phone (not key 0) do I HAVE to program it as a PVR key? And if i want this # to forward two times can I also build it as a dummy DN on a 500 port? Thank you.
 
If you don't want it as a PVR you can set the trunk in it's own route and auto terminate the trunk to a specified dn. This can be a phantom if you like.
 
create a new route? can you just point me in the right direction as far as what load(s)? and what is the difference between doing it this way and making it a PVR? does one way have any advantage over another? thank you VERY MUCH
 
If you want to forward no answer then you can't use PVR. For both PVR & an auto terminate setup you will need to create a new RDB in LD16. For an auto terminate route, in lD16 set AUTO = YES. In LD14, change the route & member to your new route & set ATDN to the extn your pointing it to
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top