GalacticZero
MIS
Ok, trying to change and reconfigure the printers for a 2 terminal posiTouch 5.22 system.
Orginal Config
Term1/POS bar printer
Term2/ Food printer
New setup:
Term1/POS 2 printers Hot and Cold (both on the serial ports of a IBM terminal or one on serial and one on ethernet)
Term2 Bar Printer on serial port
What is confusing is all the screens to setup printers. There seem to be no printers hooked up to the terminals (or associated with them) in the hardware setup portion. I see configurations for printer routing, backup, etc. Just need some general pointers to get this sorted out.
Thanks,
Franklyn
PS, this may be a duplicate post yet I can't find the first one.
Orginal Config
Term1/POS bar printer
Term2/ Food printer
New setup:
Term1/POS 2 printers Hot and Cold (both on the serial ports of a IBM terminal or one on serial and one on ethernet)
Term2 Bar Printer on serial port
What is confusing is all the screens to setup printers. There seem to be no printers hooked up to the terminals (or associated with them) in the hardware setup portion. I see configurations for printer routing, backup, etc. Just need some general pointers to get this sorted out.
Thanks,
Franklyn
PS, this may be a duplicate post yet I can't find the first one.