bobbywires
Technical User
my carrier is porting a new jersey number to my new york T1.
How do i program that number to a DID on my G3 switch?
Here is the first page of my T1.
TRUNK GROUP
Group Number: 1 Group Type: isdn CDR Reports: y
Group Name: Outside Call COR: 50 TN: 1 TAC: 800
Direction: two-way Outgoing Display? y
Dial Access? y Busy Threshold: 50 Night Service:
Queue Length: 0
Service Type: tie Auth Code? n TestCall ITC: rest
Far End Test Line No:
TestCall BCC: 2
TRUNK PARAMETERS
Codeset to Send Display: 6 Codeset to Send National IEs: 6
Max Message Size to Send: 260 Charge Advice: none
Supplementary Service Protocol: a Digit Handling (in/out): enbloc/enbloc
Trunk Hunt: descend
Digital Loss Group: 13
Calling Number - Delete: Insert: Numbering Format: pub-unk
Bit Rate: 1200 Synchronization: async Duplex: full
Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 0
How do i program that number to a DID on my G3 switch?
Here is the first page of my T1.
TRUNK GROUP
Group Number: 1 Group Type: isdn CDR Reports: y
Group Name: Outside Call COR: 50 TN: 1 TAC: 800
Direction: two-way Outgoing Display? y
Dial Access? y Busy Threshold: 50 Night Service:
Queue Length: 0
Service Type: tie Auth Code? n TestCall ITC: rest
Far End Test Line No:
TestCall BCC: 2
TRUNK PARAMETERS
Codeset to Send Display: 6 Codeset to Send National IEs: 6
Max Message Size to Send: 260 Charge Advice: none
Supplementary Service Protocol: a Digit Handling (in/out): enbloc/enbloc
Trunk Hunt: descend
Digital Loss Group: 13
Calling Number - Delete: Insert: Numbering Format: pub-unk
Bit Rate: 1200 Synchronization: async Duplex: full
Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 0