Port 2500 and Pix 506e

[tallguy804]

I have a new device that has to be installed on our network. The company selling this device is telling me I have to open port 2500 on my Pix.

I am using pix device mamager 3.0 to interface with the pix but I can not figure out how to configure it so tht traffic can use this port.

Any help would be greatly appricated.

 

[KiscoKid]

Hi

Try looking at the following link and selecting the specific PDM version you have.

These user guides are very detailed and should break it down nicely for you I think. At the very least, it should prove to be a worthwhile document to save to your desktop.

Hope this helps

 

[NetworkGhost]

Does 2500 need to be opened inbound or outbound?

 

[KiscoKid]

Dangit. Forgot the link:

http://www.cisco.com/en/US/products/sw/netmgtsw/ps2032/products_user_guide_list.html