Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
POLYCOM Soundstation IP 7000 w/ HiPath 4000 v7 1
- Thread starter favtech1
- Start date
-
1
- #2
Add it in as SBCSU with SIP
http to the IP address of the unit
Username: Polycom
Password 234
If you are outside North America then remove the Dialling Patterns as they are set for North America Dialling Codes only...
Other Problems:
Problem
A SIP device (phone,polycom conference unit,etc) created in the HiPath
4000 can make calls but when another user tries to call it, they see
'not possible' on the display.
Solution
The issue occurs when the SIP station is created with an Optidx other than 10.
The proper setting for a DSS1 device (SIP) is 10.
The Optidx table can be viewed in ZAND:OPTITBL. The SIP devices in the 4000 use DSS1 as the protocol.
http to the IP address of the unit
Username: Polycom
Password 234
If you are outside North America then remove the Dialling Patterns as they are set for North America Dialling Codes only...
Other Problems:
Problem
A SIP device (phone,polycom conference unit,etc) created in the HiPath
4000 can make calls but when another user tries to call it, they see
'not possible' on the display.
Solution
The issue occurs when the SIP station is created with an Optidx other than 10.
The proper setting for a DSS1 device (SIP) is 10.
The Optidx table can be viewed in ZAND:OPTITBL. The SIP devices in the 4000 use DSS1 as the protocol.
- Status