Policy Based Routing

[YDHSmartin]

I am having problems configuring PBR on a 1760 router, which i need to send local traffic one route back to the main site, and all other traffic (ie. Inernet traffic) to another router 1600 series which is connected locally, and managed by BT.

The config i am putting on, just seems to stop the traffic at the 1760, and is not passing the internet traffic on to the internet.

The config I am adding is as follows.

route-map internet permit 10
match ip address 10
set ip next-hop 172.17.134.65
!
!
access-list 10 deny 10.131.128.0 0.0.63.255
access-list 10 deny 172.16.0.0 0.0.255.255
access-list 10 deny 172.17.0.0 0.0.255.255
access-list 10 deny 172.19.0.0 0.0.255.255
access-list 10 deny 172.20.0.0 0.0.255.255
access-list 10 deny 172.21.0.0 0.0.255.255
access-list 10 deny 172.24.0.0 0.0.255.255
access-list 10 deny 192.168.0.0 0.0.255.255
access-list 10 permit ip any

all of the addresses in the access list are address ranges in use across our network, and all this traffic is being routed as expected using ospf.

I am sure that it is something simple which I am missing out, and would be very gratefull of any help on this one.

regards