shsimjee
Programmer
- May 2, 2012
- 5
i am writing to a pole display (com1) from my clipper program
when i was using windows 98 the message used to write to the
pole display. since changing to windows xp i get an error
error term/0 print error quit / retry. how do i overcome this error.
if i mode com1:96,n,8,1 then do a dir > com1
the pole display will display the directory but from my program
this error occurs
attach sample of my program
when i was using windows 98 the message used to write to the
pole display. since changing to windows xp i get an error
error term/0 print error quit / retry. how do i overcome this error.
if i mode com1:96,n,8,1 then do a dir > com1
the pole display will display the directory but from my program
this error occurs
attach sample of my program
