Point to Point ARS magix systems

[pabell]

We have connected 2 magix systems using INA cards at
both ends channels 1-12 DATA 13-23 Voice 24 D-channel
we are doing centralized voicemail can udp calls to and from both sites but are blocked from calling through to the other side be it copper 70 or Flexpath (891)

FROM SITE A
ars table
2
list 1 (area code 508,978)
pool 890point to point t1)
frl 0
digit 9 (inserts 9 for other side)

site A
pool 70 copper (channels 1-16)
pool 890 Point to point (channels 41-63)D-64
pool 891 Flexpath (PRI) (channels 17-39)D-40

site b
pool 70 copper (channels 1-8
pool 891 point to point (channels 9-31) D-32

site A & B
udp tables are table 1
digits 3 delete 0 frl 0


site B only (used to send calls to site A with Voicemail
except table 2
digits 3 delete 3 insert 770

ALL EXTENSIONS ARE SET FOR FRL 3 BOTH SIDES

we can dial 9 and then the 11 digit number from site A
see it pick up Trunk from point to point (trunk name
is displayed)
but get the wave off after 11 digits
yet we can call form site B and see it go over thier
trunks in group 70

is this a trunk to trunk issue (not remote fwd)
what else could it be because both sides dispaly the same
trouble

sorry about long post Thank You for any and
all replys

Pabell

 

[pabell]

FYI :

side B should read POOL 890 POINT TO POINT !
Pabell

 

[killbox]

Remote access under lines and trunks and switch numbers under UDP.

KILLBOX

 

[pabell]

Thanks !
I did put switch ID on both sides
SITE A 841-863 are see to 21

SITE B 817-839 are set to 22

its the REMOTE ACCESS part I missed

Thanks

Pabell

 

[killbox]

No problem

KILLBOX