PNI Digit Removal

[mitelgear]

I have a cluster with 5 nodes all using the same PNI digits. The cluster is SDS enabled on version 4.2. I need to remove the PNI digits. Will this just be a case of removing the digits from each element or just from one element and SDS will synch the other controllers ? The problem I have is that, I have a Qsig link to a mobile network and the cluster digits are sent through the Qsig link as well and I have tried absorbing the digits but calls over the link fail. Any idea's on how I can route calls over the Qsig without sending the PNI digits or would it be easier to just remove the PNI digits from the cluster ?

 

[Billz66]

PNI is only required for multiple clusters

if you only have 1 cluster - just remove it.

If I never did anything I'd never done before , I'd never do anything.....

 

[LoopyLou]

I think removing the PNI would be the preferred option. I would think you would have to do each controller indivdually.

I'd tell you a UDP joke but I'm afraid you won't get it. TCP jokes are the best because you always get them.