plotting/exporting to JPEG format 1

[PAULCALLAGHAN]

I'm using autoCAD LT 2000. I want to create(?) a JPEG file from an existing DWG file. I'm using the plot command, and selecting the JPEG driver, as stated in the on-line help.

When I click on the partial view button, I get the message 'effective area too small to display'. What am I doing wrong? What setting should I be adjusting?

Any tips/suggestions would be greatly appreciated.

 

[TCARPENTER]

When you specify jpeg output, instead of sheet size, you specify the size in pixels, not inches.

HTH
Todd