Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Plot Problem with Xerox 510
- Thread starter han810
- Start date
TCARPENTER
Programmer
han810,
Speaking from experience with a Xerox 8830, the supplied Xerox drivers didn't work - we wound up using HP 755 CM drivers within AutoCAD to get the plotter to produce what we needed. You may try HP's 750, 755, 1055, (etc) and see if that gets you what you need. Also, check your CTB file setup, and try playing with the screening, dithering, and grayscale settings. Also make sure within the printer properties that this particular option is either on/available whatever.
HTH
Todd
Speaking from experience with a Xerox 8830, the supplied Xerox drivers didn't work - we wound up using HP 755 CM drivers within AutoCAD to get the plotter to produce what we needed. You may try HP's 750, 755, 1055, (etc) and see if that gets you what you need. Also, check your CTB file setup, and try playing with the screening, dithering, and grayscale settings. Also make sure within the printer properties that this particular option is either on/available whatever.
HTH
Todd
- Status
Similar threads
- Locked
- Question