sayoudbilel
Programmer
Please tell me how to configure h.323 on emg800 and mg100:
A : pabx(emg800) sit 1 : plan num 32x.(emg800)
B : pabx sit(mg100) 2 : plan num 33xx (mg100)
Question .
On MG100 in H.323 ATTR incoming (362) [N], it was possible to register From IP Address = UNKNOWN at the same time in the necessary group of lines.
There is nothing like that on EMG800, is there an H.323 Incoming Routing Table (328) menu where you can specify only IP, can you put UNKNOWN here?
PLZ HLEP ME CONFIGURATION IP TRUNK (h323 only) BETWIN EMG800 AND MG100
A : pabx(emg800) sit 1 : plan num 32x.(emg800)
B : pabx sit(mg100) 2 : plan num 33xx (mg100)
Question .
On MG100 in H.323 ATTR incoming (362) [N], it was possible to register From IP Address = UNKNOWN at the same time in the necessary group of lines.
There is nothing like that on EMG800, is there an H.323 Incoming Routing Table (328) menu where you can specify only IP, can you put UNKNOWN here?
PLZ HLEP ME CONFIGURATION IP TRUNK (h323 only) BETWIN EMG800 AND MG100
