Please help with cisco 831

[196819681968]

I got 2 used cisco routers, soho and 831. I set up the soho through 10.10.10.1 web ( pc-cisco-modem) in 5 min but I got problems with the 831. I did reset the password and I did some configuration stuff but I can not make it work with the 10.10.10.1 web. What can I do? Can I copy the conf from the soho and paste into the 831? Thanks Here are the 2 conf I got:
soho:
cisco#show ip interface brief
Interface IP-Address OK? Method Status Prot
ocol
Ethernet0 10.10.10.1 YES NVRAM up up

Ethernet1 unassigned YES NVRAM up down

Dialer1 unassigned YES NVRAM up up

Virtual-Access1 unassigned YES unset up up

831:

Ethernet0 10.10.10.1 YES NVRAM up up

Ethernet1 unassigned YES NVRAM up down

FastEthernet1 unassigned YES unset down down

FastEthernet2 unassigned YES unset down down

FastEthernet3 unassigned YES unset down down

FastEthernet4 unassigned YES unset down down

PS I am a newbie...

 

[Minue]

Hello
What's the model of the SOHO router and the GUI that you used.I think the 831 will need the cisco SDM.In any case you can copy the whole conf from the SOHO router edit it to suit the 831 and the paste into the router.

Regards

 

[Lemon13]

u cant have 10.10.10.1 on both interfaces, give the 831 a 10.10.10.2

 

[196819681968]

The SOHO is 91 ( 12.2(8R)YN .
How can I copy the conf from one to another?
I got the SDM but I can not open it with the 831.Something is not conf right on 831.

I try to set up the 831 for my mother so I will not have both set up on the same network.

10.10.10.1 on both interf? Can you please explain?

 

[Minue]

Hello
To copy the conf from the SOHO 91,do a "show start or show run" in the terminal window high-light the lines and right click and copy.Then paste the contents to notepad and save it.Then copy from notepad into the 831 terminal window.You will have to be in config mode.Like the below:
Router831(config)#

To use SDM will need a basic conf on the router like the below one.Also you will need to install java on your PC.

R1(config)# username ciscosdm privilege 15 password 0 ciscosdm
R1(config)# ip http server
R1(config)# ip http authentication local
R1(config)# line vty 0 4
R1(config-line)# login local
R1(config-line)# transport input telnet
Regards

 

[196819681968]

Thank you, I'll try that.
After I paste the new conf to 831 should I save it somehow?

 

[Minue]

Yes!The command is :

Router831# copy run start

Regards

 

[196819681968]

Thanks a million, it worked !!!!!!!!!