Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

pLEASE ADVISE COMMAND TO REMOVE VIRTUAL EXTENSION FROM ONE DIAL PLAN AND ADD TO ANOTHER

Status
Not open for further replies.

ashutosh2501

Technical User
Feb 13, 2015
36
IN
ADD-WABE:2500,,,TIE,N,,,,,,,,;

<DEL-WABE:2500,,,TIE,N,,,,,,,,;
M33: VALUE TYPE DOES NOT CORRESPOND TO TYPE IN VALUE TABLE
TYPE = ?
TYPE : DESIRED OPTION
CHARACTERISTIC : REQUIRED CONDITIONAL
POSS. VALUES : DPLN DIAL PLAN / FEATURE ACCESS GROUP
CD ACCESS CODE / STATION NUMBER
TYPE = DPLN
DPLN = 0
M10: SUPERFLUOUS PARAMETERS HAVE BEEN DELETED FROM COMMAND
M12: PLEASE CONFIRM COMMAND
DEL-WABE:DPLN,0;
M16: COMMAND PROCESSING ABORTED
<

WILL THIS DELETE THE DIAL PLAN ENTIRELY OR ONLY ENTRY "2500" FROM DIAL PLAN
 
Firstly DIS-WABE:GEN,2500;

If it shows as R - Reserved over on the right hand side
then you can delete it safely

DEL-WABE:CD,2500,,,TIE;
 
@ sbcsu
But since this is a virtual extension, how do i make it route to a physical extension number in this case operator?
 
If it is a TIE then it can not be a Virtual Extension.

If you want 2500 to route to the Operator
ADD-WABE:2500,,,ATNDDID,N;
ADD-VFGKZ:ATNDGR,
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top