Trying to get a VPN set up between my pix 515e (running 6.3(4))and a 3rd party checkpoint NG r54. I need to NAT my source traffic, and have the following config:
access-list 101 permit ip 10.1.1.0 255.255.255.128 192.168.1.0 255.255.255.0
access-list 102 permit ip 172.16.1.0 255.255.255.128 192.168.1.0 255.255.255.0
nat (inside) 2 access-list 101 0 0
global (outside) 2 172.16.1.0 netmask 255.255.255.128
crypto ipsec transform-set ESP-DES-SHA esp-des esp-sha-hmac
crypto map vpn 10 ipsec-isakmp
crypto map vpn 10 match address 102
crypto map vpn 10 set pfs group2
crypto map vpn 10 set peer 217.x.x.x
crypto map vpn 10 set transform-set ESP-DES-SHA
crypto map vpn 10 set security-association lifetime seconds 3600 kilobytes 4608000
crypto map vpn interface outside
isakmp enable outside
isakmp key ******** address 217.x.x.x netmask 255.255.255.255
isakmp policy 10 authentication pre-share
isakmp policy 10 encryption des
isakmp policy 10 hash sha
isakmp policy 10 group 1
isakmp policy 10 lifetime 86400
So acl 101 is for the NAT, and acl 102 is for the crypto- the 3rd party encryption domain uses the 172 addresses as that's all they should see from my side.
Should this work?
access-list 101 permit ip 10.1.1.0 255.255.255.128 192.168.1.0 255.255.255.0
access-list 102 permit ip 172.16.1.0 255.255.255.128 192.168.1.0 255.255.255.0
nat (inside) 2 access-list 101 0 0
global (outside) 2 172.16.1.0 netmask 255.255.255.128
crypto ipsec transform-set ESP-DES-SHA esp-des esp-sha-hmac
crypto map vpn 10 ipsec-isakmp
crypto map vpn 10 match address 102
crypto map vpn 10 set pfs group2
crypto map vpn 10 set peer 217.x.x.x
crypto map vpn 10 set transform-set ESP-DES-SHA
crypto map vpn 10 set security-association lifetime seconds 3600 kilobytes 4608000
crypto map vpn interface outside
isakmp enable outside
isakmp key ******** address 217.x.x.x netmask 255.255.255.255
isakmp policy 10 authentication pre-share
isakmp policy 10 encryption des
isakmp policy 10 hash sha
isakmp policy 10 group 1
isakmp policy 10 lifetime 86400
So acl 101 is for the NAT, and acl 102 is for the crypto- the 3rd party encryption domain uses the 172 addresses as that's all they should see from my side.
Should this work?