I have a PIX 515E firewall. I set up PPTP VPN, and am able to connect to the network from home. If I do an IPCONFIG, I get the proper IP address DNS entry on my VPN connection. (This was obtained from the PIX.) I can ping addresses on the internal network.
I set up a 2003 server with routing and remote access inside, but I seem to be missing a piece: When I open the VPN connection I'm not prompted to logon to the domain. Also, I can't browse the network or ping by name.
Should I be assigning IP addresses using the PIX, or is there a way to allow my internal DHCP server to assign the client IP settings? Also, how do you make the client logon to the domain once the VPN connection is established?
I'm reading the MS documentation on Routing and Remote access, but I'm a little pressed for time.
Thanks in advance.
I set up a 2003 server with routing and remote access inside, but I seem to be missing a piece: When I open the VPN connection I'm not prompted to logon to the domain. Also, I can't browse the network or ping by name.
Should I be assigning IP addresses using the PIX, or is there a way to allow my internal DHCP server to assign the client IP settings? Also, how do you make the client logon to the domain once the VPN connection is established?
I'm reading the MS documentation on Routing and Remote access, but I'm a little pressed for time.
Thanks in advance.