Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

PIX connection to 2 ISPs (routerman may have the answer!)

Status
Not open for further replies.

sunyasee

ISP
Apr 8, 2002
94
GB
Hi

I have a network with two ISP connections. I want to use both links so that effectively I have a default route over both connections, I have an ASA and obviously it is not possible just to add in two default routes. Routerman suggested in an earlier thread that you can do this by setting a default route for one ISP interface and then using a reverse NAT rule for the other line to spoof the source address of incoming hosts on the other ISP link. Routerman wrote in an earlier thread..

'I have set up a similar system, using 2 ISP's. The way I did it was to connect each ISP into a different interface in the PIX, and use inbound NAT to `spoof' the outside source IP addresses. This way I could determine source of the outside IP address ranges, so could write routes in the PIX to control the return traffic.

Reason I did this was to provide Internal users default access to the Internet using a default route via the outside interface security 0, and routes back to VPN via another interface.'

Does anyone have a configuration that shows how this is done?

Thanks



----

Sunyasee
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top