PIX 6.01 - wont take commands

[Madrox]

I'm trying to let port 8003 through to a particular IP address and I use this command

conduit permit tcp host x.x.x.x eq 8003 any

enter it with no errors and when i try to telnet to that IP or use nmap it doesn't show up. I even write mem to no avail. The external IP is set to an internal and we have port 1723 and 9500 open and functioning fine.

any ideas?

 

[Madrox]

Any ideas? Do I simply need to reboot this thing?

 

[brianinms]

Did you try clearing your translations?