PIX 506e and VPN

[mojo1979]

Hi,

I would like to create a simple remote VPN whereby users can vpn from remote sites and access resources on my network. To begin with I could just use PPTP to get it working, and then develop it from there.

What command lines should I add?

Thanks!!

Steven

 

[horus42]

Try this

http://www.elifulkerson.com/articles/cisco-pix-pptp-setup/

 

[Supergrrover]

I would skip pptp and do ipsec. Much better for ease of use, security, standards, etc. Here is page that has all the guides you would need to setup your pix.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/prod_configuration_examples_list.html

Brent
Systems Engineer / Consultant
CCNP, CCSP

 

[mojo1979]

ok, thanks, looking at the list of config i would need the following, correct? -

http://www.cisco.com/en/US/products...s_configuration_example09186a0080093f89.shtml

Just a quick question - do I have to include all the highlighted command lines in my config??