Pix 501Config

[que71]

Hello,
I am new to the forum and Cisco Pixfirewalls. I am trying to allow citrix traffic into my network to a specific server. I have a static IP from my ISP. I can pass the traffic but when I do the only machine that can access the internet is the citrix server. The rest of my network is down as far as internet traffic goes. I could use a little help to figure out what I am missing in my configuration. Thanks in advance for the help.

PIX Version 6.3(1)
interface ethernet0 auto
interface ethernet1 100full
nameif ethernet0 outside security0
nameif ethernet1 inside security100
enable password 8Ry2YjIyt7RRXU24 encrypted


passwd 2KFQnbNIdI.2KYOU encrypted
hostname pixfirewall
domain-name ciscopix.com
fixup protocol ftp 21es the filtering of p
fixup protocol h323 h225 1720
fixup protocol h323 ras 1718-1719
snmp-server Provide SNMP
fixup protocol http 80
fixup protocol ils 389
ssh Ad
fixup protocol rsh 514sole, set idle timeout
fixup protocol rtsp 554
fixup protocol sip 5060 list of active
fixup protocol sip udp 5060SSH session
fixup protocol skinny 2000
fixup protocol smtp 25ure one-to-one address
fixup protocol sqlnet 1521
names
pager lines 24sysopt
mtu outside 1500tional option
mtu inside 1500
ip address outside Public IP & Netmask PIX console and set idle

timeout
ip address inside 192.168.1.10 255.255.255.0
terminal Set terminal line
ip audit info action alarm
ip audit attack action alarmault TFTP se
arp timeout 14400 traffic statisti
global (outside) 1 interface
uauth
timeout xlate 0:05:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 rpc 0:10:00 h225

1:00:00
timeout h323 0:05:00 mgcp 0:05:00 sip 0:30:00 sip_media 0:02:00
timeout uauth 0:05:00 absolute
aaa-server TACACS+ protocol tacacs+
aaa-server RADIUS protocol radius
aaa-server LOCAL protocol local
http server enable
http 192.168.1.0 255.255.255.0 inside
no snmp-server location
no snmp-server contact
snmp-server community public
no snmp-server enable traps
floodguard enable
telnet timeout 5
ssh timeout 5
console timeout 0
dhcpd address 192.168.1.11-192.168.1.138 inside
dhcpd lease 3600
dhcpd ping_timeout 750
dhcpd auto_config outside
terminal width 80

 

[dx1]

I don't see a NAT statement in there.
nat 1 0 0

 

[que71]

When I entered nat 1 0 0 Duplicate NAT entry was returned. Thanks for the idea.

 

[tonymullen]

is that definitely the whole config? As dx1 said there is no nat statement listed. Also I can't see any access lists or static lines which would be required to open up an machine on the inside with a static IP.