I have just started using a Pipeline 75 for connection to an ISP. I am getting a busy signal when dialing into the pot line for voice. This is an irradic behavior as sometimes it will work properly and sometimes not. It does not seem to matter if I am connected with both B1 and B2 or just B1. In fact it seems to work a little better when I set the configuration to always use both the B channels. I have used another router on this line and it worked properly so I am reasonably convinced it is not a provisioning problem. Any insite?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Pipeline 75 Inbound Busy Signal on POTS
- Thread starter threck
- Start date
It appears to be a provisoning issue with your provider. Give them a call and let them know you need to call in on the line when its busy. “Reserve your right to think, for even to think wrongly is better than not to think at all”
Fisher CCNA, Network+
![[americanflag]](/data/assets/smilies/americanflag.gif "[americanflag] [americanflag]")
Fisher CCNA, Network+
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question