Pinout for TN464F to Connect Cisco Router

[Kely]

Does anyone knows the pinout for TN464F to connect Cisco router (RJ-45)? Thanks a lot

Kelvin

 

[dimas]

Hi
Definity 25-pairs Amphenol connector :
22,47 pins - Rx,
23,48 pins - Tx,

Cisco 5300-series E1 RJ45 connector:

http://www.cisco.com/en/US/products..._guide_chapter09186a008007cfac.html#wp1014561

1,2 - Rx
4,5 - Tx

I think you should cross-connect pairs
Tx-Rx,
Rx-Tx .

 

[maverick2689]

What card are you using to output from the Cisco?

 

[Kely]

Thanks everyone.

The voice card we are installed in our Cisco router is "NM-HDV=".

 

[archie819]

To make your job easier, you can use a Voice x-over pins
(1,2,4,5)cable and plug this into the Cisco and punch down the opposite end on pairs 22 and 23 of the amphenol where you have your PRI card on..

 

[Kely]

Thanks Archie819.
Sorry for my silly question again.. is that means... I should connect the pin like followings -

Cisco -- Lucent
1&2 <--> 22
4&5 <--> 23

Seems like I have some mis-understanding.. ^^

 

[maverick2689]

That should do it.