Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Pinout for DB9 to RJ45 for Epson TM88 Aloha
- Thread starter ltso
- Start date
CosgroveAloha
IS-IT--Management
DB9 to RJ45
2- Orange
3- Black
5- Green
8- Yellow
DB25 to RJ45
2- Orange
3- Black
7- Green
20- Yellow
Some older posiflex models have a loop back db9 that I could never figure out. This is something that would already be on the computer, usually in the com1 position. You shouldn't have any problems as long as your dip switches are set. For the tm88, unscrew the small plate on the bottom and look for the number 1 & 2 labeling each bank of switches. Make sure it's set to:
Set 1:
3,5,6,7 on, rest off
Set 2:
all off.
Those pin outs change according to the connection you are using. TM88's support usb (OPOS), serial, and parallel.
2- Orange
3- Black
5- Green
8- Yellow
DB25 to RJ45
2- Orange
3- Black
7- Green
20- Yellow
Some older posiflex models have a loop back db9 that I could never figure out. This is something that would already be on the computer, usually in the com1 position. You shouldn't have any problems as long as your dip switches are set. For the tm88, unscrew the small plate on the bottom and look for the number 1 & 2 labeling each bank of switches. Make sure it's set to:
Set 1:
3,5,6,7 on, rest off
Set 2:
all off.
Those pin outs change according to the connection you are using. TM88's support usb (OPOS), serial, and parallel.
- Status
Similar threads
- Locked
- Question