Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pinout for 25-pin connector attached to a tty punch tape 1

Status
Not open for further replies.
wheat

wheat

IS-IT--Management
Apr 8, 2003
1
KR
Anyone know what pinout I need to use for a 25-pin connector attached to a tty tape punch. I'm going from server to patch panel to mux to modem, and then at a remote site from modem to mux to tty.
 
Sort by date Sort by votes
Oh my gosh, Somebody still using a tape punch....
What on earth for?
Most tape punch units were of a standard serial design.
 
Upvote 0 Downvote
I think you need to use null-modem cable between modem and your device.
Basically, if you would use straight cable to connect terminal to it, you need to use null-modem to connect modem and vice-versa.
Also, have you tried similar setup in the past? You may need to configure your modem for reverse dialup.

Good luck.
 
Upvote 0 Downvote
Can you still buy paper tape? We quit using them in the early '80's. Jim

 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

dukane123
  • Locked
  • Question
Resistors on punch blocks
Replies
3
Views
198
Dexman
Dexman
UnplugMe
  • Locked
  • Question
RJ45 connector performance
Replies
10
Views
310
Commshark
Commshark
pccsipoffice
  • Locked
  • Question
Shielded 25 pair cable for machine shop
Replies
8
Views
142
libellis
libellis
DallasTXtech
  • Locked
  • Question
Grounding and Bonding Requirements on 1" EMT Pipe for CAT6 runs.
Replies
8
Views
338
Wanebo
Wanebo
Lee_G
  • Locked
  • Question
Using 3 Pair wires to extend a home network
Replies
5
Views
555
LkEErie
LkEErie

Part and Inventory Search

Sponsor

Back
Top