got this printer in with bent frame would click and grind badly after fixing paper feed rollers in front (they were bound up) im now getting it to say warming up gets to 99 percent then says warming up forever never comes out of this state no error code or anything i tried cleaning the drum sensor even removed it and checked for build up but made no difference. any suggestion would be greatly appreciated?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Phaser 860n warming up never ready
- Thread starter Axxuss
- Start date
Smaug1Tech
Vendor
Howdy, The drum heater has stuck flaps, and or H to D gap is off.One or more lamps may have blown. Pull the heater and check.
- Status
Similar threads
- Locked
- Question
- Locked
- Question