My Phaser 860 does not complete its warmup without throwing up the 15,004.45 error. I noticed that it never becomes warm to the touch on the outside, and the white light is no longer visible through the side panel. I read on here that it could be a burned out bulb...any hints on how to replace the bulb, where it can be purchased, or any other problems that might be the cause?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Phaser 860 no light during warmup (bad bulb?) 3
- Thread starter bradrh
- Start date
-
1
- #2
-
2
- #3
printerfixers
Technical User
There are 2 quartz halogen lamps in the drum heater that have probably burned out. They are GE 120V B1 Q150 T2.5/CL.
- Status
