Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Phaser 850 / Failure 07,002,44 1
- Thread starter Schiwy
- Start date
-
1
- #2
07,002.44:
PM_FAULT_PROCESS_
MOTOR_STALL
Verify process motor operation with the Process Motor diagnostic test. Also exercise processes run with the process motor; transfix, drum maintenance and head tilt. This can be caused by the power control board. The process motor may have more than one task initiated. Reset all solenoids and the pressure roller prior to cycling power.
This is a cut and paste from a pdf I have. I have never experienced this error myself, so I cannot lend you any help with how to resolve it other than what is listed above. I do know there is a floppy diag. disk that you can use to run diags on clutches and stuff. Let me know if you need anything else.
PM_FAULT_PROCESS_
MOTOR_STALL
Verify process motor operation with the Process Motor diagnostic test. Also exercise processes run with the process motor; transfix, drum maintenance and head tilt. This can be caused by the power control board. The process motor may have more than one task initiated. Reset all solenoids and the pressure roller prior to cycling power.
This is a cut and paste from a pdf I have. I have never experienced this error myself, so I cannot lend you any help with how to resolve it other than what is listed above. I do know there is a floppy diag. disk that you can use to run diags on clutches and stuff. Let me know if you need anything else.
- Status
Similar threads
- Locked
- Question
- Locked
- Question