Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Phaser 850 Error 08.001.15064
- Thread starter Jimcouk
- Start date
I suspect the error is something like 08.001.44.15064, in this case it means cap fault home sensor. The sensor is not activated when expected. 3 posible causes. 1 sensor broken, replace right i/o board, 2 sensor arm broken or the arm on the cap wip belt to actuate the sensor broken. Replace arm. 3 Cap geometry incorrect. Remove covers, top cover and inkloader. remove metal dustcover over the printhaed. Move the cap (CWP) assy upword and check left and right side. Is the highd on the left and right side the same if not change accordingly. how, on the left and right belt you find a connection to close the two belts. open the and the belt wil loosen up a little, just enoug to chance a little on the possition. assemble the same way as disassemle but inverse all steps. Greetz DAny
- Status
Similar threads
- Locked
- Question
