Phaser 840, 16.001.43 error 1

[merzcm]

Hi all,

I replaced the preheater bulbs in my Phaser 840 and now I am getting a 16.001.43 error. I followed the instructions on the preheater lamp kit that I bought, but I am at a loss to understand what this error is or how to fix it.

Any ideas?

Thanks,

Chris

 

[ifixprinters]

Chris - check the wiring harness connection on the preheater (it goes through the rh side wall). It sounds like it isn't connected properly. If that's not the case, the bulbs you installed could be faulty, or the preheater could've been damaged in the repair.