Hi I have a low usage 8200 approx 150 pages printed that has been in a cuboard for a year. On Powerup I guess the head was blocked as there was streaky test prints and in some cases just completely black prints.
Maintenance Roller had bits of ink stuck to it and Drum had ink on it.
Ran the Power on Warm up procedure to pass some ink through the heads.
Nearly a block later.Tried the start up routine and it passes the cleaner page through and then hangs on Printing the test page.
Set switch 1 and ran through the diags and exercises and they all seem to pass.
I have cleaned the ink sticking to the maintenance roller and run the DM Maint pass a number of times to clean the drum and oiled the transfix.
The Drum is now clean as is the maintenance roller, all diags run clean, temps reached OK, sensors cycle on and off.
However after printing the cleaner page, the test page does not print and its sounds like the the page pick up is trying but not succeeding as the Printer makes about six load clunks and hangs with Printing page 1.
Can anyone advise as to what the problem might be and other checks I can make?
TIA
Maintenance Roller had bits of ink stuck to it and Drum had ink on it.
Ran the Power on Warm up procedure to pass some ink through the heads.
Nearly a block later.Tried the start up routine and it passes the cleaner page through and then hangs on Printing the test page.
Set switch 1 and ran through the diags and exercises and they all seem to pass.
I have cleaned the ink sticking to the maintenance roller and run the DM Maint pass a number of times to clean the drum and oiled the transfix.
The Drum is now clean as is the maintenance roller, all diags run clean, temps reached OK, sensors cycle on and off.
However after printing the cleaner page, the test page does not print and its sounds like the the page pick up is trying but not succeeding as the Printer makes about six load clunks and hangs with Printing page 1.
Can anyone advise as to what the problem might be and other checks I can make?
TIA