Phaser 8200 showing 07.002.44:17829 error code

[zwingli]

hi,

I just got this used Phaser 8200 and its showing the 07.002.44:17829 error code. I can't do anything from there, no precise information is to be found on the xerox website, and the support service says they don't know what that particular error code means, and that I should call for service... Anyone has a clue? Many thanks.

 

[CULTOFLON]

This is a process motor stall error. Verify process motor operation with the Process Motor diagnostic
test. Also exercise processes run with the process motor;
transfix, drum maintenance and head tilt. This can be caused by
the power control board. The process motor may have more than
one task initiated. Reset all solenoids and the pressure roller
prior to cycling power.
No transistions are observed for the compound gear sensor,