Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Phaser 8200 exit jam

Status
Not open for further replies.
elstevo

elstevo

Technical User
Nov 10, 2005
4
US
the front panel says to open the exit cover and clear jam -but there is no jam. I already put a piece of tape over the black rubber pad on the solenoid on the upper right side -didn't fix the jam. Until I get this cleared up, I can't print. Can anyone help?
 
Sort by date Sort by votes
It is probably stuck in the preheat entry sensor. Remove the drum heater and you should find it.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

SYNTHEA
  • Locked
  • Question
Phaser 6250 won't print BLACK. (refer to closed thread 723-1262185)
Replies
0
Views
68
SYNTHEA
SYNTHEA
colorprinters
  • Locked
  • Question
XEROX PHASER 7100 BLURRY PRINT
Replies
1
Views
86
jackestean
jackestean
ELECTRICWARRIOR
  • Locked
  • Question
xerox 6250 jam
Replies
0
Views
61
ELECTRICWARRIOR
ELECTRICWARRIOR
frimu
  • Locked
  • Question
Phaser 8400 - Black arrows are not matching exactly
Replies
1
Views
93
frimu
frimu
JessicaGalbreth
  • Locked
  • Question
Xerox Phaser 7750 Error 20 IDE
Replies
0
Views
67
JessicaGalbreth
JessicaGalbreth

Part and Inventory Search

Sponsor

Back
Top