Phaser 8200 error code 15.004.43:3991 1

[member007]

My phaser 8200 is very slow in warming up and eventually will display "Printer Error- contact service: Report Fault 15.004.43:3991

Anyone here have exprience with this error ?

Thank in advance ...!!

 

[bisawest]

You could look at various other threads within this forum for the answer, but here goes. Your heater bulbs are probably burned out. This is the most likely cause of this problem. Other people have said that you could get them from a hardware store, but I don't know for sure. I hope this helps. Good Luck, and have a nice day!!!

 

[TCouch]

Correct. You can get these at most stores that sell light bulbs. I've gotten them from Home Depot, & Lowes. Have also gotten them from lighting stores. The bulbs should run you around the $5.00 range. I pay $5.75 each for mine, since Alaska has higher shipping costs. The bulbs you seek, are your standard tube halogens. 118mm 150W. You will need two of them.

Timothy N. Couch
A1 Printech
Anchorage, AK